Things to Do if the Dryer Won’t Start

If your problem won’t start, then the problem may be caused by a certain part. Find out which parts are the culprits and replace them accordingly. However, dryer repair is not a do-it-yourself job. It’s something that an expert in dryer repair Frederick should do if you want to get the best possible results.

Be reminded that dryers are powered either by electricity or gas. They are not supposed to be handled by individuals who are not well-trained in working with these things. If you try to fix the dryer yourself and you don’t know too much about it, then you might be doing more harm than good. Listed below are the parts that are likely to be faulty in case your dryer fails to start.

1. Door Switch

Did you know that dryers have a door switch? This is more like a safety precaution to ensure that the dryer will only work if and when the door is shut. It may be the cause of the defect in certain types of dryers. To test if the door switch is working, a continuity test is usually performed.

2. Thermal Fuse

The installation of a thermal fuse is yet another safety feature added not only to dryers but to almost all types of home appliances as well. Thermal fuses are very sensitive as they will keep the dryer from turning on if the temperature inside is too hot. Some dryers use more than one fuse and it’s important to find and replace all of them as necessary.

3. Start Switch

If there’s a door switch, there’s also a start switch. This switch is the one you find in the main console. It turns on the dryer when pushed or rotated. If you turn on the switch and the dryer doesn’t work, it pays to test it for continuity.

4. Motor

The motor that runs inside electric or gas dryers is responsible for its rotating function. If the motor is defective, then it will not start at all. You may still hear a humming inside but it simply won’t work. If you suspect that it’s the motor that’s defective, then it has to be removed and replaced. Do so by taking out the front panel and then followed by the drum to get access to it. Testing motors should only be done by a qualified professional.

5. Control Board

The control boards of dyers are mostly electronically controlled. As such, they use a circuit board to control all of the components of the dryer, such as the timer. Sometimes, it’s the board that is causing the issue. Check if there are burn marks on the board as these signify that there are circuits that have shorted out.

6. Timer

Sometimes, the circuit board is working but the timer isn’t. If that’s the case, then you have to replace just the timer. To check if it is faulty, then the small motor that’s connected to it should be checked. To have its contacts checked, the timer has to be entirely removed from the dryer.

Leave a Reply

Your email address will not be published. Required fields are marked *